ich möchte hier ein RAID 1 System aufbauen bzw. die vorhandene hdd im Rechner spiegeln, allerdings funktioniert es nicht so wie ich mir wünsche;)....folgende Fehlermelddung bekomme ich wenn ich das / raid device erstellen möchte
md: could not bd_claim hda2
md: error, md_import_device() returned -16
mdadm hot add failed for /dev/hda2 Invalid argument
das Problem begründet sich wohl darauf das die Plattengeometrie verschieden ist....ich weiß aber leider nicht wie ich das nun korrigieren kann ohne datenverlust zu erhalten. hier noch mal die Ausgabe von fdisk -l
parted /dev/hdc
GNU Parted 1.6.9
Copyright (C) 1998, 1999, 2000, 2001, 2002, 2003 Free Software Foundation, Inc.
This program is free software, covered by the GNU General Public License.
This program is distributed in the hope that it will be useful, but WITHOUT ANY
WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A
PARTICULAR PURPOSE. See the GNU General Public License for more details.
Using /dev/hdc
Warning: Unable to align partition properly. This probably means that another
partitioning tool generated an incorrect partition table, because it didn't have
the correct BIOS geometry. It is safe to ignore,but ignoring may cause
(fixable) problems with some boot loaders.
Ignore/Cancel? i
(parted) print
Disk geometry for /dev/hdc: 0.000-76319.085 megabytes
Disk label type: msdos
Minor Start End Type Filesystem Flags
1 0.031 101.975 primary ext3 boot, raid
2 101.975 36169.782 primary ext3 raid
3 36169.783 38162.219 primary linux-swap raid